Trumpet vine flower made from crepe paper

#v16678

Make your own long-lasting branches covered in trumpet vine flowers. Cut the pieces for your trumpet vines out of crepe paper using the stencil and colour them in with a watercolour marker. Assemble the parts to the stem with glue around a floral wire using either a glue gun or Multi Glue. With Multi Glue the drying time is ½ - 1 hour hour per step.

Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1   Print and cut out the template sheet, which you can find as a separate PDF file at the bottom of this page. Cut out all the pieces for a flower branch with 3 flowers. Remember to cut along the guide lines shown on the template.
Guide step %d
2   Spray a little water on the petal – the marks will work best when applied wet on wet.
Guide step %d
3   Colour the top and bottom with a watercolour marker – and use both pink and orange. The colours will blend together on the wet paper. Drying time: 1 hour.
Guide step %d
4   Glue the petal together to form a tube.
Guide step %d
5   Turn out the top of the tube using a bone folder.
Guide step %d
6   Shape the stamens by rolling the strips between two fingers.
Guide step %d
7   Glue the stamen onto a piece of floral wire by rolling it around in a single layer. Cut the thin threads in half and use them as side branches. Then, use the strong floral wire as a stem.
Guide step %d
8   Shape the tube-shaped petal and give the bottom-third a little roundness using your thumb. Then fold it together and glue it onto the stem.
Guide step %d
9   Finish the flower by glueing on three green leaves – place the leaves just below the tube form.
Guide step %d
10   Cover the stem with the light green strip. Stretch the strip out and glue down the end of the strip – start at the bottom of the green leaves and continue diagonally down over the flower stem. Remember to glue along the way.
Guide step %d
11   Add the side branches with flowers to the crepe covering with a little glue – place them about 10 cm down the stem.
Guide step %d
Template   Print the template here.
Attached file: Download
Also go exploring in

More Information

Make your own long-lasting branches covered in trumpet vine flowers. Cut the pieces for your trumpet vines out of crepe paper using the stencil and colour them in with a watercolour marker. Assemble the parts to the stem with glue around a floral wire using either a glue gun or Multi Glue. With Multi Glue the drying time is ½ - 1 hour hour per step.

More Information
SKUv16678
SeasonBasic

Description

Copyright © 2021-present Magento, Inc. All rights reserved.