Stamped designs using foam rubber sheets
#v16130
Print pictures with craft paint. Etching designs into a foam rubber sheet with a pencil is easy.
#v16130
How to do it Download the templates/recipes
1 Cut an 8.5 x 18.5 cm piece of foam rubber or to your chosen size. Etch the design into the foam rubber sheet using a pencil, creating an indentation where you draw with the pencil. A tip: Draw thick lines as these a more visible on the finished print.
2 Roll paint onto the etched design on the foam rubber sheet.
3 Transfer the design onto a piece of watercolour paper. Press firmly (not too hard) onto the back of the foam rubber sheet as there can be some paint left in the indentations.
4 Cut out the printed design and attach it onto the inside of a tray using matt decoupage lacquer. Attach a picture hanger onto the back of the tray and use as a picture frame.
5 A tray with a glued-on patterned design.
Also go exploring in
