A Pirate Keyring Fob from Shrink Plastic

#v14856

These pre-printed designs on shrink plastic are coloured in with colouring pencils. The figures are cut out, a hole is made at the top, they are shrunk in a household oven at 170°C and attached to a keyring to make a key fob.

Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1   Colour in the pre-printed design on the shrink plastic sheet.
Guide step %d
2   Cut out the figure with a pair of scissors and make a hole at the top using punch pliers. It can then be attached as a key fob on a keyring. Remember that the hole shrinks as well.
Guide step %d
3   Place the figure on a baking sheet covered with baking paper. Put in a household oven at 170 °C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.
Guide step %d
4   Attach the figure to the keyring using a round jump ring. Now squeeze the round jump ring with flat nose pliers to close it.
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.